工業用三乙二醇檢測

工業用三乙二醇檢測項目報價？??解決方案？??檢測周期？??樣品要求？

點 擊 解 答??

GB/T 14571.2-2018工業用乙二醇試驗方法 第2部分:純度和雜質的測定 氣相色譜法

GB/T 14571的本部分規定了測定工業用乙二醇中純度及雜質氣相色譜法的原理、試劑或材料、儀器設備、樣品、試驗步驟、試驗數據處理、精密度、質量保證和控制、試驗報告。本部分適用于測定純度不低于98.0%(質量分?jǐn)?shù))的工業用乙二醇樣品。其中，1，2-丙二醇和三乙二醇的檢測限為0.002 0%(質量分?jǐn)?shù))，1，3-二氧雜烷-2-甲醇、二乙二醇、1，2-丁二醇、1，4-丁二醇、1，2-己二醇和碳酸乙烯酯的檢測限為0.001 0%(質量分?jǐn)?shù))。

GB 32048-2015乙二醇單位產品能源消耗限額

本標準規定了乙二醇單位產品能源消耗（簡稱能耗）限額的技術要求、統計范圍和計算方法、節能管理與措施。本標準適用于乙烯法和合成氣法乙二醇生產企業單位產品能耗的計算、考核，以及對新建或改擴建項目的能耗控制。

HG/T 2843-1997化肥產品 化學分析常用標準滴定溶液、標準溶液、試劑溶液和指示劑溶液

本標準規定了化肥產品中化學分析常用標準滴定溶液的配制、標定和貯存方法；標準溶液、試劑溶液和指示劑溶液的配制和貯存方法。

HG/T 3270-2002工業用異丁醇

本標準規定了工業用異丁醇的要求、試驗方法、檢驗規則及標志、包裝、運輸、貯存和安全等。 本標準適用于羰基合成法生產的工業用異丁醇。該產品是有機合成原料，主要用于制造石油添加劑、抗氧劑、增塑劑、乙酸酯等。

SH/T 1054-2022工業用二乙二醇純度和雜質的測定 氣相色譜法

本文件規定了工業用二乙二醇的純度及雜質測定的氣相色譜法。本文件適用于純度不低于99.0%(質量分?jǐn)?shù))的工業用二乙二醇樣品。其中乙二醇、三乙二醇、1,3-二氧戊環-2-甲醇、1,4-二氧六環-2-醇和1,4-丁二醇等雜質的低測定含量為0.0020%(質量分?jǐn)?shù))。

SH/T 1795-2015工業用三乙二醇

本標準規定了工業用三乙二醇的要求、試驗方法、檢驗規則、標志、包裝、運輸、貯存和安全。本標準適用于環氧乙烷水合生產乙二醇得到的副產物三乙二醇，其主要用途是用作天然氣、油田伴生氣和二氧化碳的脫水劑，硝化纖維素、橡膠和樹脂等的溶劑，干燥劑、潤滑劑和增塑劑。分子式：C<下標6>H<下標14>O<下標4>相對分子質量：150.184（按2011相對原子質量）。

SH/T 1796-2015工業用三乙二醇純度與雜質的測定 氣相色譜法

本標準規定了用氣相色譜法測定工業用三乙二醇的純度和雜質含量。本標準適用于三乙二醇含量不低于80.0%（質量分?jǐn)?shù)），乙二醇、二乙二醇雜質含量不低于0.01%（質量分?jǐn)?shù)）、四乙二醇雜質含量不低于0.02%（質量分?jǐn)?shù)）樣品的測定。

SN/T 2360.8-2009進出口食品添加劑檢驗規程 第8部分:膠基糖果中基礎劑物質及其配料

SN/T 2360的本部分規定了進出口食品添加劑膠基糖果中基礎劑物質及其配料的技術要求、抽樣、檢驗、結果評價、綜合評定和處置和復驗的原則。本部分適用于進出口食品添加劑膠基糖果中基礎劑物質及其配料的監督檢驗。

SN/T 2360.25-2009進出口食品添加劑檢驗規程 第25部分:食品工業用加工助劑

SN/T 2360的本部分規定了進出口食品添加劑(食品工業用加工助劑)的技術要求、抽樣、檢驗、結果評價、綜合評定和處置及復驗的原則。本部分適用于進出口食品添加劑(食品工業用加工助劑)的監督檢驗。

TD/T 1043.1-2013暗管改良鹽堿地技術規程 第1部分 ：土壤調查

TD/T 1043的本部分為暗管改良鹽堿地工程的規劃設計、施工管理、監測評價及其后期維護管理提供土壤調查參數指標和各參數的測定方法。規定了暗管改良區域土壤調查的一般程序,土壤環境、理化性質、水文特征等調查指標,提供了各調查指標的測定方法以及土壤調查報告的編寫規范等內容。本部分適用于以暗管改良鹽堿地為目的的土壤調查工作和我國北方地區鹽土或鹽化土壤的改良利用工程,也適應于農田暗管排水工程進行防澇除漬等。在改善土壤滲透性條件下,本部分可指導堿化土壤的改良利用應用暗管改堿技術。

HJ 458-2009環境標志產品技術要求.家用洗滌劑

本標準規定了家用洗滌劑類環境標志產品的基本要求、技術內容和檢驗方法。本標準適用于家用洗滌劑，包括織物洗滌劑和護理劑、餐具和果蔬用洗滌劑、硬表面清洗劑和洗手液。

CNS 4087-1977三乙二醇

本標準適用于一般工業用之三乙二醇。

BS 1427-2009水分析用現場試驗方法指南

This British Standard describes information and guidance on testmethods for the analysis of industrial and other waters which areapplicable outside of a conventional laboratory as either in situon?site tests; or the use of a close suitable designated room/areatesting facility. For some tests this could include dedicated spacein a designated vehicle or caravan. These test methods can relateto compliance, water quality and process control purposes. Norecommendation is given as to which test is applicable to a particulartype of water, nor is it implied that in any given case all tests or anyparticular suite of tests are necessary. The selection of tests depends onlocal requirements and conditions. Samples requiring preservation forsubsequent analysis are outside of the scope of this British Standard.Certain tests such as adsorbable organic halides (AOX), chemicaloxygen demand (COD), total organic carbon (TOC) and total nitrogenneed a suitable designated test room/area facility and are notconsidered suitable for testing outside of these designated areas.Sample stability is not considered to be a significant problem as mosttest-kit measurements are carried out with minimal delay.Most of the methods described in this standard can be applicable foruse on clean or lightly polluted waters which might have undergonetreatment or been modified for industrial use. Typically, the types ofwaters for which the tests are intended include the following:a) boiler waters;b) cooling waters;c) waters from hot water systems;d) waters from air conditioning systems;e) waters from industrial air washing systems;f) potable waters;g) ground waters;h) surface waters;i) process waters; andj) swimming pool waters.Certain more heavily polluted waters can be routinely tested forcertain control purposes for specific determinands using the testmethods cited in this British Standard. Such waters include:1) sewage works influents and effluents;2) selected industrial effluents.Emergency screening analysis for major pollution incidents is notcovered (see commentary).The on?site methods outlined in this British Standard includetitrimetric, colorimetric and instrumental analytical techniques andalso includes consideration of commercial test-kits: their generalprinciples and formats available. It is generally accepted that in theUK, the vast majority of on?site measurements are carried out usingcommercial test-kits rather than user-devised test-kit type methodsfollowing similar equivalent method procedures to those used inconventional laboratories. Also the designated room/area testingfacility titrimetric methods described in Section 4 of this standardmight require staff with a greater degree of training than commercialtest-kit titrimetric methods which can be readily used outside of theseareas. These methods are less likely to be used by non?analysts thanthe more robust test-kit titrimetric methods.The technique used and principle of the designated room/area testingfacility titrimetric method are described within each test method andeach method is self?contained within a standard format.This British Standard does not apply to radioactivity, ecotoxicity (SeePersoone et al., 2000 [4]) or microbiological testing. Spot tests are notcovered (Jungris, 1997 [5]).Many of the relevant methods are suitable for analysis for the waterframework directive (see Note and SWIFT 2003 [6]), water for humanconsumption (see Note) and for monitoring of discharges to waterand sewer (EA, 2006 [7] and Dixon and Gardner, 1997 [8]).